网站转让 → 您的公司名称

Regulating valves are often blocked or blocked by anti-blockage (card) methods here! uuuuuuuuuu
1）清洗法
1) Cleaning method
管路中的焊渣、铁锈、渣子等在节流口、导向部位、下阀盖平衡孔内造成堵塞或卡住使阀芯曲面、导向面产生拉伤和划痕、密封面上产生压痕等。这经常发生于新投运系统和大修后投运初期。这是最常见的故障。遇此情况，必须卸开进行清洗，除掉渣物，如密封面受到损伤还应研磨；同时将底塞打开，以冲掉从平衡孔掉入下阀盖内的渣物，并对管路进行冲洗。投运前，让调节阀全开，介质流动一段时间后再纳入正常运行。
The welding slag, rust and slag in the pipeline cause blockage or blockage in the throttle orifice, the guide position and the balance hole of the lower valve cover, which results in the pull and scratch of the valve core surface, the guide surface and the indentation on the sealing surface. This often occurs in the early stages of operation after new operation systems and major repairs. This is the most common failure. In this case, it is necessary to unload and clean, remove slag, if the sealing surface is damaged, it should be grinded; at the same time, the bottom plug should be opened to wash away the slag falling from the balance hole into the lower valve cover, and flush the pipeline. Before putting into operation, let the control valve be fully opened and the medium flow for a period of time before it is brought into normal operation.xueqiu.75ix.cn    huangyang.75ix.cn    tabai.75ix.cn
bitao.75ix.cn    hongfeng.75ix.cn     mujin.75ix.cn